Technology

Realizing that the installation and setup of autogas systems available on the market was very difficult, we decided to develop our own products.
We wanted to eliminate the need of mapping the correct injection timings after the installation.
Car manufacturers have got a few months to complete this task during the development of a new engine. During the conversion the same has had to be achieved within a few hours and has been the main reason for a lot of unsuccessful conversions.


Similar technology but entirely different concept ...

Our patented technology enables conversion specialists to focus on mass conversion instead of repairing unnecessary mistakes which result from difficulties of rapid mapping.

Our products are pre-configured. There is no need for the technician's manual intervention,  so you can focus on functionality and aesthetics!
You only need to run an OBDII/EOBD checkup of correct operation.
For additional settings simply select nozzles with the correct diameter and the correct pressure regulation.

Recommend this article...